09-16-2020 03:49 AM - edited 07-05-2021 12:31 PM
Good Day.
I have a 5508 WLC, and need to enable Clean Air.
I have no access to a LAB environment, and need to know if the AP will reboot after the Clean Air is enabled ?
Also, when I need to change the "channel list" in the DCA page on the 2.4gHz radios ?
Kind Regards
Solved! Go to Solution.
09-18-2020 05:58 AM - edited 09-18-2020 05:59 AM
DCA can not be adjusted without interruption and the next DCA run can/will change the channels again and thus can cause a short interruption.
[edit]
Corrected my answer
09-16-2020 03:53 AM
No. It won't.
09-16-2020 05:29 AM
Thanx Leo !
You 100% sure ? Dont wan't to bring down the whole network . . .. .
Also, when I need to change the "channel list" in the DCA page on the 2.4gHz radios ?
Regards
09-16-2020 05:52 AM
Don't believe me? Open a TAC Case.
09-16-2020 05:57 AM
and for the second part of my question ?
Also, when I need to change the "channel list" in the DCA page on the 2.4gHz radios ?
09-16-2020 06:11 AM
The radios need to be turned OFF before you can change the channels list.
09-18-2020 05:58 AM - edited 09-18-2020 05:59 AM
DCA can not be adjusted without interruption and the next DCA run can/will change the channels again and thus can cause a short interruption.
[edit]
Corrected my answer
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: