cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

379
Views
0
Helpful
3
Replies
Highlighted
Beginner

WLC CLI Commands

Hi all

Haing recently upgraded an HA pair of 8510 to version 8.3.143.0 I suddenly found that the switches were complaining about Duplex mismatches on ports connected to APs.  I did some troubleshooting and googling and came to the conclusion that these were erroneous messages.  However I do have a couple of questions regarding some of the CLI commands I used:

 

1.  show ap config general

This displayed that the Duplex was Full, is this a report that the Duplex is configured as Full, or is it reporting that the state of the port is Full?

2. config ap ethernet duplex autho speed auto <Cisco AP>

This command is deprecated, is there another command that allows me to set the duplex and speed of the AP port(s)?

 

Kind Regards

 

Terry

3 REPLIES 3
Hall of Fame Community Legend

Re: WLC CLI Commands


@terrywatson651 wrote:

 I suddenly found that the switches were complaining about Duplex mismatches on ports connected to APs.


Don't bother troubleshooting.  It's a known bug:  FN - 70252 - Inaccurate "CDP-4-DUPLEX_MISMATCH" Messages Are Logged on AP Switchports - Software Upgrade Recommended

Everyone's tags (3)
Beginner

Re: WLC CLI Commands

Thanks for the response, however I know it's a known bug.  My questions are related to what the CLI commands are telling me rather than the issue itself.

 

Regards

 

Terry

Re: WLC CLI Commands

Please, I need help on setting up WLC5508. Have made initial configuration and can WLC via service port but cannot access via management port. Also, I cannot ping the management interface from my switch. Both management interface and service port are in different IP network.

CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards