Haing recently upgraded an HA pair of 8510 to version 220.127.116.11 I suddenly found that the switches were complaining about Duplex mismatches on ports connected to APs. I did some troubleshooting and googling and came to the conclusion that these were erroneous messages. However I do have a couple of questions regarding some of the CLI commands I used:
1. show ap config general
This displayed that the Duplex was Full, is this a report that the Duplex is configured as Full, or is it reporting that the state of the port is Full?
2. config ap ethernet duplex autho speed auto <Cisco AP>
This command is deprecated, is there another command that allows me to set the duplex and speed of the AP port(s)?
I suddenly found that the switches were complaining about Duplex mismatches on ports connected to APs.
Don't bother troubleshooting. It's a known bug: FN - 70252 - Inaccurate "CDP-4-DUPLEX_MISMATCH" Messages Are Logged on AP Switchports - Software Upgrade Recommended
Thanks for the response, however I know it's a known bug. My questions are related to what the CLI commands are telling me rather than the issue itself.
Please, I need help on setting up WLC5508. Have made initial configuration and can WLC via service port but cannot access via management port. Also, I cannot ping the management interface from my switch. Both management interface and service port are in different IP network.