02-11-2020 12:46 AM - edited 07-05-2021 11:40 AM
Hi All,
I've 2 WLC's which are configured in HA-SSO mode, During one of the HA testing Scenario, i've removed the cable from the Switch to the primary WLC and Secondary acts as the primary unit and all the operations work normally. but when i plug the network cable back to the switch of primary controller. Primary controller reboots and then it forms the HA again and take over as the primary unit.
My concern is this natural behavior of the primary WLC to reboot to regain it's Primary active status ?
Solved! Go to Solution.
02-11-2020 12:52 AM
As its a natural behaviour.
Regards
Dont forget to arte helpful posts
02-11-2020 12:52 AM
As its a natural behaviour.
Regards
Dont forget to arte helpful posts
02-11-2020 01:17 AM
thank you sandeep, can you share some documentation link for reference.
02-11-2020 01:19 AM
Here is the deployment guide...
check the steps to simulate Box failover.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-7/High_Availability_DG.html
Regards
Dont forget to rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: