01-31-2018 10:53 AM - edited 07-05-2021 08:11 AM
AP 2702e I could not get the AP to join it say image not on controller but if I connect it back to 8.2 it loads fine connects fine using ap3g2-rcvk9w8-tar.153-3.JG1.tar
Did Also load the AP Bundle on 8.5
01-31-2018 10:59 AM
Hi
Cab you show the ouput of "show ap bundle all" ?
-If I helped you somehow, please, rate it as useful.-
01-31-2018 11:15 AM
01-31-2018 11:19 AM
AIR-CAP2702E-A-K9
01-31-2018 11:20 AM
01-31-2018 10:26 PM
Hi Gary,
Ideally , if a 2700 AP connects to a WLC running 8.2 image , it must not download the image 153-3.JG1. This AP image is available on 8.6 code. The 8.5 code would download image 15.3(3)JF(x) to the APs.
After associating to the 8.2 WLC , does the AP show the image as ap3g2-rcvk9w8-tar.153-3.JG1.tar ? It should not. That's the recovery image which is the initial image for the AP (before the AP downloads the image from the WLC).
As Flavio said , let's get the output of "show ap bundle all". This output will show if ap3g2 image is present in the WLC bundle or not.
Cheers,
Manish
02-01-2018 09:30 AM
I was able to join 2700i ok I try again with the 2700e If it doesn't work I add capture
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide