06-05-2013 08:14 AM - edited 07-04-2021 12:11 AM
Hi Friens,
I want to see the running configuration of WLC as like routers and switches. But in WLC running config it is giving all the inventory, AP details and everything.
Is ther any cmd to see the configuration in commands format?
Regards,
Vijay.
Solved! Go to Solution.
06-05-2013 08:26 AM
sure.
show running-config no-ap
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
06-05-2013 09:08 AM
You need to take a look at it... one has the config command and the other doesn't. If your looking for the configuration, then you just need to backup the WLC as you will not be able to paste the show run-config.
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
06-05-2013 08:26 AM
sure.
show running-config no-ap
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
06-05-2013 08:37 AM
Thanks steve.
Is this command output and the config backup through WLC GUI will be same?
regards,
Vijay
06-05-2013 08:47 AM
they should be pretty darn close to the same.
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
06-05-2013 09:08 AM
You need to take a look at it... one has the config command and the other doesn't. If your looking for the configuration, then you just need to backup the WLC as you will not be able to paste the show run-config.
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
06-05-2013 10:02 AM
Thanks for the reply.
If I add config command in the show run command output, will i be able to paste it in WLC?
Regards,
Vijay
06-05-2013 12:00 PM
You can, but the order in which the config is pasted makes a difference. That is why there is no true cut and paste method.
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
08-16-2013 07:36 AM
That command wouldn't work for my 5508 running 7.4.110.0 code
But this did :
show run-config no-ap
Just a slight syntax issue =)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: