ā03-03-2013 12:52 AM - edited ā07-03-2021 11:39 PM
Hi,
Is there is is any posibility to run WLC4402 and 104x family in H-REAP mode.
Some documantaion says yes , some no. What is the true?
Marcin
Solved! Go to Solution.
ā03-03-2013 06:55 AM
It's the same... When they mention 1040, that means 104x. Just like the 3600... That includes the 3602's. there are no 1040 actual part number as its just a reference. The 104x is supported.
ā03-03-2013 01:32 AM
yes
--------------------------
please make sure to rate correct answers
ā03-03-2013 01:36 AM
Which software is minimal?
Can I use H-REAP on one group of ap's and other group for ap's without H-REAP?
ā03-03-2013 01:40 AM
Oher question is : all ap's (1040,1041,1042) in 104x familly?
ā03-03-2013 02:06 AM
Hi ,
Want to use 1041.
ā03-03-2013 03:10 AM
7.0 or later release on controller is enough.
check this:
ā03-03-2013 05:14 AM
Hi,
this doc https://supportforums.cisco.com/docs/DOC-20868 like many other it says that it is only 1040 supported.
Can you check what about 1041 and 1042? This is 4402 with the latest software.
ā03-03-2013 06:55 AM
It's the same... When they mention 1040, that means 104x. Just like the 3600... That includes the 3602's. there are no 1040 actual part number as its just a reference. The 104x is supported.
ā03-03-2013 07:02 AM
ok thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide