05-26-2020 05:02 AM - edited 07-05-2021 12:05 PM
Dears,
I am about installing WLC 9800-L-F port-channel to 9500 switch but i read in the deployment guide that 10G/1G uplink not support port-channel as below
Data port behavior:
• The 10G/Multigigabit copper port (or 10G/1G fiber port) will be disabled if link aggregation (LAG) is
enabled – only 4x 2.5G/1G ports can be used for link aggregation.
My question, is it true that i won't be able to do LAG on the 10G Fiber, and if i want to do that must use the other ports 4x 2.5G/1G ports
Thanks and BR;
Solved! Go to Solution.
05-26-2020 04:13 PM
05-26-2020 07:54 AM
05-27-2020 01:38 AM - edited 05-27-2020 01:39 AM
But as the data sheet below, there are two uplink fiber 10G/1G
05-26-2020 01:04 PM
I'm in the same boat. I don't seem to see any mention of that on the guide you sent. Is this still the case?
05-26-2020 04:13 PM
05-26-2020 04:23 PM
05-27-2020 01:49 AM
Thanks
05-27-2020 01:48 AM
the document has been updated
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: