".4. Uploaded the final.pem file and it install without any problems.5. In this example this Certificate used is from RapidSSL, so it could be from others as well.
In case of this is a renewal cert i.e. second time install on WLC, Don't forget to keep the original copy of OpenSSL that worked for the first time. That will make cert renewal much easier.
Sometimes Open SSL v 1.x seems to cause issues. Some TAC engineers always used v0.9.8 also asked that the CSR doc have notes added to them mentioning issues with 1.x. Also they checked the chained and unchain CSR doc for the WLC and both do now contain a note about using v0.9.8:
Install and open the OpenSSL application. In Windows, by default, openssl.exe is located at C:\ > openssl > bin.Note: Cisco recommends that you use OpenSSL v0.9.8 for Windows.
WLC versions 184.108.40.206 and later support chained certificates (up to a level of 2)
Level 0 – Use of only a server certificate on WLC
Level 1 – Use of server certificate on WLC and a CA root certificate
Level 2 – Use of server certificate on WLC, one single CA intermediate certificate, and a CA root certificate.
Level 3 - Use of server certificate on WLC, two CA intermediate certificate, and a CA root certificate.
The Anchor WLC is configured with HTTPS. When a guest user connects to the wireless guest network they will be presented with a WLC self signed certificate or an expired certificate. As such, this will cause the “please accept” this certificate screen.
Hello, I have just setup a test vWLC in a lab and connected a AIR-CAP2702I-E-K, the controller can see the AP, I have configured a few SSIDs but I cannot see them being broadcasted?Any suggestions? Wireless
Just started to investigate a medium/large network setup where it seems all of the LWAPs are connected to switchports configured as trunks and all of the LWAPs are in local mode. Each switchport is configured like this... interface GigabitEthernet2/0...
I have:Product/Model Number : AIR-SAP1602I-E-K9withCisco IOS Software, C1600 Software (AP1G2-K9W7-M), Version 15.3(3)JC, RELEASE SOFTWARE (fc1)I need to have internet access via eth in a deep place of my basement. So I bought a small thing called wifi ext...
Hi together, i am new in this community and hopefully i have a easy question for you experts, but i am working hours on it and can´t figure out what is wrong.I have running a wlc 5500 with 16 AP´s, different VLans for different ISP, everything is running ...
Hello, I'm wondering if when you set multiple mandatory data rates, example 3, that means a client MUST support these 3 data rates or it has to support one among the 3 mandatory data rates ? Example, most of our rf profiles 5Ghz Data Rates are c...