My customer has a 5520 WLC running 22.214.171.124 with currently 160 x 2802i APs connected in flex connect mode, across multiple sites. Each of the sites has their APs in their own AP group.
There are only three SSIDs configured on the WLC and these are being broadcast to all the AP groups, there are no APs left in the default group.
When I run a "show client summary ssid devicetype" from the cli, some clients are showing as being in an idle state but connected to a unknown "mesh_ssid". I have checked the APs in question and they are in the correct AP groups based on their site. The mesh_ssid is also not configured on the WLC.
Does anybody know where this unknown "mesh_ssid" comes from and how to stop clients apparently connecting to it?
I have two WLC 5520 on HA SOO with flex connect APs 702i, and I have configured SSID corporate flexconnect local switching with 802.1x authentication using ISE server 2.3 as AAA server. so when we tested the network, we have faced a problem of loss ...
New setup of 1852e access points in production area using 802.1x authentication to Windows NPS server, machine certificates. Also have printers connecting with NPS user name and password.Computer clients authenticate and connect fine. The problem is,...
Hi all, Is it required for an Cisco outdoor 1562i or e model to have a NEMA enclosure installed as well? The data sheet mentions humidity are levels 0 - 95% , non-condensing. So I'm guessing that they're required?Cisco Aironet 1560 Series ...