Happy to Introduce “Wireless Config Analyzer Express” the next gen cloud based evolution of the WLC Config Analyzer (WLCCA) with powerful checks for Wireless LAN Controllers , Access Points (AP), Radio Frequency (RF), Mobility, Security, Mesh and Flex Configurations. “WCAE” provides state of art RF summary including stats summarization at WLC, AP group, Flex group level and RF health analysis at WLC, AP group, Flex group level.
Get the experience of hundreds of cases applied to your network in seconds
AP Data Summarization
Get list of AP HW types and operational modes in use
Quick data summarization for main RF stats, see what is happening at WLC, or AP group/Flex group levels
Simplified RF analysis tool, translate those RF statistics into simple Health report
Log File Summarization
List all messages in a short list, get counts and initial/end time
WLC running AireOS
File Types Supported
Sh run-config -> recommended option, gives you more bang for the buck
WCAE is a public facing tool and anyone with a valid CEC ID can enjoy its benefits. Please feel free to share this tool with your customers and partners. Note: Ensure that pop-up block is disabled for the page on your browser to run the script. Here are some cool screenshots from WCAE:
Just wondering what the best practice is on using DHCP proxy mode vs DHCP bridging mode for roaming clients (L2 / L3 roam)? Does the DHCP proxy feature add significant time to the DHCP handshake and cause roaming clients to lose packets when they go ...
Hi all, I am having issues setting up a few Aironet 1262s (AIR-LAP1262N-E-K9) They are powered from a 3560 PoE-8 (only one at a time) and they power up...The power comes on and the light flashes green for bit (I assume booting)The light then is ...
Hi all, I am using WLC 3504 and i have created a open ssid that require web auth. I have also enabled a lobby admin account on my WLC to create accounts for guests to connect to this ssid. The default ip of the interface of this ssid is 220.127.116.11. For ...
Hello everyone,I am a new customer of Cisco Access Point AIR-AP2802E-E-K9C. I don't have much experience with this class of hardware Cisco. Could someone help me, how to configure this AP? I have experience with switches and routers. I would like, to this...
Dear all, I cannot reimage AP1852i through rommon mode .I tried below commands but it doesn't work. When it boot, it will load the old image (the old image has an issue so I cannot access to controller cli or webui)tftpboot AIR-AP1850-K9-8-5-151...