User would like to configure couple of autonomous 1262's and would like to put the Ethernet interface out on Internet subnet and have the
clients get a RFC 1918 address from the radio's. One Linksys is setup in a way that the clients are PAT'ing off the Ethernet interface when they go to the Internet.
Is this possible with these clients or do user have to put the AP Ethernet interface into the same subnet with the DHCP scope? They don't have enough Internet IP's to hand out to every wireless client.
Yes, this is possible. you can have the AP be on one subnet, and the clients be on another, so long as the switch you are connecting to can be configured for a dot1q trunk.
If it can't be configured as such, the clients are going to get an IP in the same subnet as the AP. Which is not necessarily a bad thing. In this scenario, you would still want the AP on a 1918 address space.
We have a single 2702I-B series AP that is unable to join our 9800-80 WLC. The other 100+ APs at the same site, same IP space, and same model were able to join no problem. For the AP with the issue, we do see a Join attempt, but the 9800 simpl...
Hi, aironet 2702 AP (autonomous mode) is it possible to use it as wireless repeater for all wireless networks, or only the compatible cisco root wlan's? I have a 9120axe with EWC configured and i want to use 2702 as wireless repeater. Thanks for...
Hello all,I am a pretty novice when it comes to wireless. I am doing some health checks for a customers wireless and I am a little confused on the firmware. They have a mix of CAP1620I and AP1815I access points in their environment. On the 1620s, I see th...
Hi All, I'm currently planning a migration from a Cisco 5508 WLC with 3700/3800 access points to a Cisco 9800 WLC with 9100 series access points. Due to various requirements and constraints, the customer does not want to change the SSID names, authen...
Could it be that MIC certificate expiration could break a mesh network ?
A mesh network with older APs has been running fine but then just stops working when the APs were power cycled.
We have applied the "config ap c...