May 2: Final version 126.96.36.199 has been posted to CCO. Beta process is over
For any new issue during this test, please write to firstname.lastname@example.org, pre-existing problems would be directed through normal TAC support channels, the image is TAC supported until CCO release of final code
AS_5500* can be used for Wism2/2500/5500 controller types
AS_7500* can be used for 7500/8500
AS_CTVM can be used for vWLC
Changes included on this release
Support for AP700w/2700
ap702W Tx Utilization showing 100% w/ few clients and only ping traffic
multicast fails with 1130 & 1240
7500 crash during test of validation of snmpv3user lifetime on HA
1240 & 1130 telnet ssh config change fails
WLC silent crash - Kernel Dump - 188.8.131.52
WLC Crash when changing interface group config on 184.108.40.206
Daisy Chain configuration unable to exceed 90Mbps backhaul xfer rates
WLC: DHCP w/VLAN pooling takes too long to switch vlans
Interface inside a group gets Dirty due to DHCP flood by client and NAK
PI:SNMP operation to Device failed Table too large, possible agent loop
Webauth fails on segmented HTTP GET
Treat ff02::2:ffxx:xxxx/104 as link local multicast
Crash on field manipulation for mgmtuser_create.html
Wism2 crash due to DP failure on 220.127.116.11
WISM2 silent crash on 18.104.22.168 code
AAA override client gets assigned to dynamic interface on roam on 7.4mr2
WiSM2 does not process fragmented client certificate
HA false switch over due to keepalives loss possibly in the kernel stack
Lightweight AP should not send jumbo frame by default
DFS Falsing from Broadcom Radio Emissions
Silver: 1530 fresh non-root doesn't join with root in low dBm
Hi Guest web auth page jump up after trying to login to Guess ssid. But when second time to login to the same ssid, the auth page would not jump up again. However we want to test it and hope to see the jump page, how can we reset it in order to see the th...
Difference in cat M1 and Cat 1 devices ? Is CAT m1 devices work in areas where CAT 1 devices work.? Is there any special antenna requirements for CATM1 devices ? could you please answer above questions ASAP. We need to take decision to buy ...
Hello Everyone, Is there any idea how to reset the GUI and CLI admin password? Worst case is i even do not have CLI mode admin password. I have forgotton the password. By the way i do not know how come my GUI admin password is expired too.....
Hi allI would like to know if exist the possibility that create one SSID Example: WMOBILITY and in this SSID restrict connection only for users that use. IPhone or Android? I'm using WLC 5508 (without ISE Authentication to users)5508 --> The users...
Saludos, No he logrado configurar el AP AIR-AP1815I-A-K9, no había configurado uno de este modelo con anterioridad, alguien que me asesoré, por favor. Ya tiene un ip, ya logré conectarme por el puerto COM y acceder a la linea de comandos pero ah...