Final build posted to CCO. 126.96.36.199, beta is closed
Thanks for your interest!
For any new issue during this test, please write to email@example.com, pre-existing problems would be directed through normal TAC support channels, the image is TAC supported until CCO release of final code
AS_5500* can be used for Wism2/2500/5500 controller types
AS_7500* can be used for 7500/8500
AS_CTVM can be used for vWLC
Issues fixed on this release
CSCur88408 LAP doesnt send discovery request to WLC IP discovered by DNS resolution
CSCur56103 Jian Active Silent crash
CSCuq27304 Apple IOS7 devices not able to pass traffic in 11v+FTDot1x wlan
CSCur44620 Radio reset after Flex+Bridge AP recovers from standalone
CSCur43050APs mfg in September/October 2014 unable to join an AireOS controller
CSCur42201 Crash on WLC apf_rogue_rule.c:2415
CSCur27551SSLv3 Poodle attack against https in wlc, CVE-2014-3566
CSCuq73468 Radius AP users not synchronizes after standalone-Connected transition
CSCur486001530 crashes after radio failure
CSCur12358 1532 AP channel announce on DFS not working
CSCur27399 ap702w lan port wired client traffic gets disturbed.
CSCur16761 outdoorAPs going to Local mode with "clear capwap privateconfig" command
CSCuq81885 DHCP fails Flexconnect Local Switching MAC Filtering RADIUS VLAN assign
Hi, I noticed that Cisco Prime Infrastructure 3.x has a feature called AP Onboarding, but it looks like it is only compatible with ME controllers. I am looking to provision/deploy a bunch of new AP's for a project. My setup:WLC...
It would be great if anyone explained why we get these errors on the Cisco Wireless controller. *dot1xMsgTask: May 31 00:04:14.261: %DOT1X-3-WPA_SEND_STATE_ERR: [PA]1x_kxsm.c:1718 Unable to send EAPOL-key msg - invalid WPA state (0) - client MA...
This is what Cisco book says about PAC phases:.....Phase 0: The PAC is generated or provisioned and installed on the client Phase 1: After they authenticate each other, they will negotiate a TLS tunnel....What will be installed on the client in phase...
I have checked the telnet / ssh function in the global settings. And global configuration is selected in the AP's advanced configuration page. Now I can ssh to all APs successfully , but I cannot telnet to all APs. The network between ...