New IEEE standard that is set to be rettified in 2007 that will be up to 10 times faster than 802.11g and have 4 times the range.
More Applications and Users, Faster Connections
With 802.11n technology, organizations gain unprecedented reliability and up to nine times the throughput of current 802.11a/b/g networks. This technology provides mobile users with:
Anytime access to network resources and applications
Optimum performance to support the growing number of mobile users
Quality of Service, for consistent voice and video over the WLAN
Reliable connections for mission-critical applications
Predictable coverage for challenging RF environments
Adoption of 802.11n wireless today protects long-term investments by delivering the performance needed to support new applications and meet user expectations for mobility.
802.11n: Mission-Critical Wireless
Create a transparent working environment across wired and wireless networks with the performance and reliability required for multimedia and business-critical applications.
Combine the mobility of wireless with the performance of wired networks in an 802.11n wireless network.
Why Choose Cisco for 802.11n?
Cisco Clean Air Cisco provides performance protection for 802.11n networks with CleanAir technology. This silicon-level intelligence creates a self-healing, self-optimizing wireless network that mitigates the impact of wireless interference.
Cisco VideoStream Provide clear, accurate video images everywhere by efficiently delivering multicast video from the wired to the wireless network.
Cisco ClientLink ClientLink, a wireless innovation, allows access points to fill in coverage holes, increase access, and provide a signal in challenging environments.
Hello, we have a Cisco 5520 WLC. I'm looking into auto-containment of rogue devices found on the network or with our SSID. However I want to get an alert of when it happens. I know the WLC itself doesn't alert, but you can send syslogs and traps to a serv...
Hi Community,Last saturday we upgraded the IOS-XE version of our C9800-40 (x2) and the standby one is in initialization state still: ESGSDC-WLC#sh redundan statemy state = 13 -ACTIVEpeer state = in progress to standby cold-bulkMode = DuplexUnit = Pri...
Hi, Im trying to deploy 2 C9115AXI-Q.But somehow, as I connect them to the network, both has the same IP address and hardware address. The output of show interface via terminal is below:GigabitEthernet0 is up, line protocol is up
Hi, I'm currently trying to setup 3 C9115AXI-Q in our office.I have set different SSID to each devices. However, once I connect 2 device together within the network, only 1 device becomes active.On top of that, the setting from device ...
Hi all,I have a topology as below:VLAN 1: default, and nativeVLAN 16: wifi 1VLAN 17: wifi 2VLAN 110: managementOn WLC, I config the management VLAN:IP: 184.108.40.206Subnet mask: 255.255.255.0Default gateway: 220.127.116.11DHCP: 18.104.22.168Port: 1VLAN identifier: 16O...