99% the above will work.. if not.. use the below manual process..
Download TFTP d32 on your laptop and install it..
- Download the latest IOS image: www.cisco.com downloads for AP801 series.
Cisco.com --- Click on the Support tab in top--- Then click Download software------ Choose Wireless --- Then select "Integrated routers and switches section" from product list-Then choose the router model - choose IOS image.. (12.4(21a)JY)
>> Now log into the AP module from the router and issue the command..
AP#debug capwap console cli OR debug lwapp console cli
AP#config t <now the config command will work>
AP(config-t)#int GIG 0 or int FA 0 <which ever is the physical interface i think its the GIG>
AP(config - int)#ip addresss <address > <mask> (make sure you have the connectivity to your laptop ip address, that is the interface ip should be able to ping the laptop ip address, that is.. both in the same subnet)
AP(config - int)#no shut
AP(config - int)#end
Now use the archive download command to upgrade the AP to Autonomous..
AP#archieve download-sw /force-reload /overwrite tftp://<TFTP ip address (laptops IP)>/<Autonomous image.tar>
Cisco 9117 &9115 Access Points (5520 WLC)Hi All, Recently installed new access (Cisco 9100 series) and continuing to have issues with roaming using laptops running Intel AX200/AX201 wireless chipset (HP Laptop G5/6/7), iPhones or older...
vWLC and AIR-CAP3602E-A-K9Hi, I a trying to set up a wireless lab. - vWLC- AIR-CAP3602I-A-K9 AP is unable to join as WLC gives log messages as *spamApTask3: Mar 03 19:04:53.505: %CAPWAP-3-JOIN_UNSUPP_AP: capwap_ac_sm.c...
Can the 9120AX perform Intelligent Capture? This document says it does.https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9120ax-series-access-points/datasheet-c78-742115.html This document says that it does NOT. (Table 5)https:...
Due to problems with one remote access point, I've tried "clear config except static ip" from WLC.But it seems this does not really a factory reset, because now I get "connection refused" when trying to telnet or ssh the ap.Ping is ok!Hostname changed, be...
Is there a "master controller" functionality in the 9800's ?I cant seem to find it anywhere, UI or config guides.Is there another way of accomplishing "master controller" ?Put one WLC in a MB group(name) by itself and only use that in discovery ?(It prope...