The output is presented in CSV format, for easy processing with any common spreadsheet application.
This version adds the capability to import AP information with no direct connection to the WLC, either through a static AP list specified in the config.ini file, or by importing the raw output of the "show ap join stats summary all" in one or more text files.
All platforms: paramiko / pycrypto / ecdsa From CLI:
pip install paramiko pycrypto ecdsa
The “pip” command requires internet access to reach the PyPI repositories via HTTPs. Should the above commands on CLI return a “file not found” error, execute the command after changing directory to the “Scripts” directory under the python installation, e.g. C:\Python27\Scripts\
The host running the script needs to have network connectivity (SSH and/or Telnet) to the Access Points. Connectivity to the Wireless LAN Controller(s) is also required unless AP information is imported through text files (version 1.2.1).
Installation and Configuration instructions:
Please refer to the release notes PDF document for more details.
The tool and documentation can be downloaded from this repository (CCO account required):
Hello together, i am currently struggling really hard to get a AP2802i to run as a Bridge / WGB Mode. I have the CAPWAP Version and the Bridge-mode should be available, but its NOT. When i try to change to mode from "local" to "bridge" i ge...
Using a WLC 5508 and ACS for web authentication for users wireless users. The virtual IP 22.214.171.124 has been always set to take the users to the authentication page. All of a sudden it stopped and is now sending users to the page attached. ...
Hello, I'm playing with two "28021-E-K9" AP with the IOS AIR-AP2800-K9-ME-8-5-151-0.tar installed in console session in CLI mode with a tftp server.When I connect both AP on my network one become Master and the other one is in the AP list. Good.But i...
Hello, I have just setup a test vWLC in a lab and connected a AIR-CAP2702I-E-K, the controller can see the AP, I have configured a few SSIDs but I cannot see them being broadcasted?Any suggestions? Wireless
Just started to investigate a medium/large network setup where it seems all of the LWAPs are connected to switchports configured as trunks and all of the LWAPs are in local mode. Each switchport is configured like this... interface GigabitEthernet2/0...