*Mar 7 15:20:40.507: %CAPWAP-5-SENDJOIN: sending Join Request to 1x.3y.247.4x
*Mar 7 15:20:40.687: status of voice_diag_test from WLC is false
Also we have entered the CAPWAP ap controller ip address directly into the AP so it shouldn't be an option 43 DHCP issue.
We have experienced same issue while adding some 1142's and found that they had a mesh configure on them out of the box for some odd reason. Take a look at your AP, sh flash: and check. 3602i AP's were delivered in MESH mode so with the advice of Cisco TAC we added the AP's to the MAC filtering table under security. Once the AP's registered we were able to change them to LOCAL mode and they came up as normal.
Hi, Should I expect any incompatibility issues between these you software versions running at the anchor and foreign controllers? According to other posts in this forum, the anchor and foreign can run different software versions, but is this true whe...
Hi. i am ordering a 2802 access point. This AP will not connect to the POE switch. Can you help me with the part code for the external power source ? I am ordering the below in Cisco portal. Can you help with the power source AIR-AP2802I-E-K9AI...
Community Live video- Understanding How Multicast Works with Cisco Wireless LAN Controllers
(Live event - formerly known as Webcast- Tuesday November 19, 2019 at 9 am Pacific/ 12 pm Eastern / 6 pm Paris)
This event had place on Tuesday 19th, Novembe...
Hi Everyone!I have a problem with some autonomous 1532E AP with version code 15.3(3)JK in a root / non-root deployment. I have a root ap and a wgb ap with a directly connected plc, since the plc is in a different vlan than the administration one...
Hello All, Here is my scenario, I upgraded a production Cisco Catalyst 3850-48F-L Switch with Denali image cat3k_caa-universalk9.16.03.09.SPA.bin and set up wireless functionality.I have wireless management, access points and wir...