Authentication Success messages not seen in the Trap logs on WLC
The Trap logs on the controller do not show any Authenticated messages. One can see DeAuthenticated messages but cannot see any Authenticated messages eventhough there are clients associated with the APs on that controller.
Check the trap log controls under MANAGEMENT>SNMP>Trap Controls. Under the client options check if 'Authentication' is enabled. By default this option is disabled since most users are interested only in the failed logs.
802.11 Association—Associate notification that is sent when the client sends an association frame.
802.11 Disassociation—Disassociate notification that is sent when the client sends a disassociation frame.
802.11 Deauthentication—Deauthenticate notification that is sent when the client sends a deauthentication frame.
802.11 Failed Authentication—Authenticate failure notification that is sent when the client sends an authentication frame with a status code other than successful.
802.11 Failed Association—Associate failure notification that is sent when the client sends an association frame with a status code other than successful.
Exclusion—Associate failure notification that is sent when a client is Exclusion Listed (blacklisted).
Authentication—Authentication notification that is sent when a client is successfully authenticated.
Max Clients Limit Reached—Notification that is sent when the maximum number of clients, defined in the Threshold field, have associated with the controller.
NAC Alert—Alert that is sent when a client joins an SNMP NAC-enabled WLAN. This notification is generated when a client on NAC-enabled SSIDs complete Layer2 authentication to inform about the client's presence to the NAC appliance. cldcClientWlanProfileName represents the profile name of the WLAN that the 802.11 wireless client is connected to. cldcClientIPAddress represents the unique IP address of the client. cldcApMacAddress represents the MAC address of the AP to which the client is associated. cldcClientQuarantineVLAN represents the quarantine VLAN for the client. cldcClientAccessVLAN represents the access VLAN for the client.
Association with Stats—Associate notification that is sent with data statistics when a client associates with the controller or roams. The data statistics include transmitted and received bytes and packets.
Disassociation with Stats—Disassociate notification that is sent with data statistics when a client disassociates from the controller. The data statistics include transmitted and received bytes and packets, SSID, and session ID.
We have a single 2702I-B series AP that is unable to join our 9800-80 WLC. The other 100+ APs at the same site, same IP space, and same model were able to join no problem. For the AP with the issue, we do see a Join attempt, but the 9800 simpl...
Hi, aironet 2702 AP (autonomous mode) is it possible to use it as wireless repeater for all wireless networks, or only the compatible cisco root wlan's? I have a 9120axe with EWC configured and i want to use 2702 as wireless repeater. Thanks for...
Hello all,I am a pretty novice when it comes to wireless. I am doing some health checks for a customers wireless and I am a little confused on the firmware. They have a mix of CAP1620I and AP1815I access points in their environment. On the 1620s, I see th...
Hi All, I'm currently planning a migration from a Cisco 5508 WLC with 3700/3800 access points to a Cisco 9800 WLC with 9100 series access points. Due to various requirements and constraints, the customer does not want to change the SSID names, authen...
Could it be that MIC certificate expiration could break a mesh network ?
A mesh network with older APs has been running fine but then just stops working when the APs were power cycled.
We have applied the "config ap c...