Somebody could help me, l have a problem with one AP 1240, it was working in LWAPP mode with my WLC, a few days ago, this AP dissasociatted to the controller and l discovered that the AP could not restart because the flasf filesystem had an error.
I was trying to restart with the available commands ( flash_init, ether_init, boot etc) but the AP doesn´t work.
Somebody knows other procedure to restart the AP 1240 ???
I have being reading about OFDMA & MU-MIMO:
MU-MIMO -> An AP can talk to more than one device at the same time
OFDMA -> An AP can divide a channel in different chunks to talk with multiple devices at a time (with less ...
I'm having trouble getting an L2 ACL to work on the Cat9800 on XE 16.11.1cI have a WLAN policy profile called nm-test-policy with a specific layer2/datalink acl defined in the running config: wireless profile policy nm-test-policyaaa-overrideautoqos ...
Hi All I have been working on existing WLC 2500 with a single individual interface with a handful wlan Ids.The interface is the management 192.168.120.0/25 192.168.121.10 the management interfaceI wanted to create an additional ID that would be dishi...
Hello All. i have 3 AP's cisco aironet 1815i (A, B, C) A is the controller.A and B working perfectly i can get an ip from dhcp and i can access my Network and the internet either,but the problem is with C i can access it with SSH connection and...