Can a Cisco Aironet 802.11b AP support WPA2 and AES?
Cisco Aironet 802.11b APs do not support WPA2 and AES.
WPA 2 is supported on this equipment:
Aironet 1130AG AP series and 1230AG AP series
Aironet 1100 AP series
Aironet 1200 AP series
Aironet 1300 AP series
Note: Equip these APs with 802.11g radios and use Cisco IOS Software Release 12.3(2)JA or later.
Note: WPA 2 and AES is also supported on Cisco Aironet 1200 series radio modules with the part numbers AIR-RM21A and AIR-RM22A. However, the Cisco Aironet 1200 radio module with the part number AIR-RM20A does not support WPA 2.
Note: Cisco Aironet 350 series products do not support WPA 2 because their radios lack AES support.
Just wondering what the best practice is on using DHCP proxy mode vs DHCP bridging mode for roaming clients (L2 / L3 roam)? Does the DHCP proxy feature add significant time to the DHCP handshake and cause roaming clients to lose packets when they go ...
Hi all, I am having issues setting up a few Aironet 1262s (AIR-LAP1262N-E-K9) They are powered from a 3560 PoE-8 (only one at a time) and they power up...The power comes on and the light flashes green for bit (I assume booting)The light then is ...
Hi all, I am using WLC 3504 and i have created a open ssid that require web auth. I have also enabled a lobby admin account on my WLC to create accounts for guests to connect to this ssid. The default ip of the interface of this ssid is 126.96.36.199. For ...
Hello everyone,I am a new customer of Cisco Access Point AIR-AP2802E-E-K9C. I don't have much experience with this class of hardware Cisco. Could someone help me, how to configure this AP? I have experience with switches and routers. I would like, to this...
Dear all, I cannot reimage AP1852i through rommon mode .I tried below commands but it doesn't work. When it boot, it will load the old image (the old image has an issue so I cannot access to controller cli or webui)tftpboot AIR-AP1850-K9-8-5-151...