The Access Point ethernet port may not be plugged into the network, or the cable may be nonfunctional.
Confirm that the access point can access devices on the wired lan and vice versa. If not verify that the ethernet cable is seated or connected properly to the access point. Check the cable and its connectors for damage. You can also try swapping out the ethernet cable for another cable, or by using a cable from a known working device. If the access point does have connectivity to the wired lan, begin narrowing down othe possible causes sucha as problems with the client to ap configuration. If you have any security enabled (i.e. wep, leap, etc.) remove the configuration and see if the problem persists.
Associated but cannot pass traffic to some devices
WLAN adapters (wireless card) / ACU (Aironet Client Utility)
Under Configuration -> Security -> Web Auth, on the new 9800 WLC you have a option called Web Auth Parameter Map.How many Web Auth Parameter Map can you have on the new 9800 WLC?I can't seem to find a number on this online. But would it be reas...
Hello, Anyone can explain the picture of AP signal. The picture shows signals strength in different angles so that we can know how strong the signal is at different angle. Do you think the picture show signal strength at some distance away from the AP? Fo...
We currently have a Cisco WLC 4402 with approximately 50 Aironet 1142 APs . When we we provision an AP both our guest and secure wlans are automatically setup on the APs. Is there a way or configuration where we could have certain APs "not" have the secur...
Hello, I'm using network environment based on AIR-AP3802I-E-K9 with WLC 5529 126.96.36.199. Could someone please tell me why some client devices which are using 2.4Ghz associating with AP only based on 802.11g?I've in NIC requirements tha...
i have tried to search everywhere without been able to get a real answer, does the vWLC (Cisco Virtual Wireless Controller) support the 802.11ac Radio Module installed on the 3600 and 3700 Cisco AP´s ?i can see the M module mentioned on the compatibi...