Viten Patel is working as Technical Marketing Engineer (Converged Access) at Cisco. He was working as Wireless Escalation Engineer - Cisco TAC and holds many wireless certification like CCIE Wireless, CCNP Wireless, CCNA Wireless, CWNA, CWSP, CWAP, CWNE#146.
This document explains about the Prime Infrastructure WorkFlow for Converged Access. There are 3 WorkFlows (Small network, Large network and Centralized network deployment). This section shows the single switch Small Branch flow.
Below is a reference topology and deployment scenario
The WorkFlow helps deploy the above mentioned features. With just a few clicks you can deploy multiple branch networks with all the wired / wireless best practices for Converged Access.
What is achieved?
Some of the benefits of using the WorkFlow includes --
Simple to use
Masks the configuration complexity
covers most of the deployment scenarios
configure onces, use many times model
intelligence and best practices inbuilt in the tool
Hello everybody,I have an issue where the captive portale won"t work properly, the problem is that I have control over the WLC only and not adipsys platform I think I did what should be done in the WLC following the official guide provided by adipsys...
I am a student at Pioneer Technology Center, Ponca City, Oklahoma. We have a Cisco 1950 Series wireless router that we wish to configure as a wireless hotspot. I am interested in how the router manages wireless connections and I would like to see a diagra...
Hello All, Having a very difficult time getting my 1702i AP to join WLC 2504. This is working fine when direct connected to PoE port on device, but when I attempt to connect to edge switchport (configured for same VLAN as AP-manager) the connec...
I am trying to setup evaluation licenses on a Catalyst 9800-CL appliance. I was told all you have to do was registered it under your Cisco smart account, and it will automatically activate the evaluation licenses for the appliance under your account. I re...
I borrowed a 'Cisco SG300-10 10 port gigabit managed switch' from work to practice things i'm learning from my CCNA course. I have tried a serial to ethernet cable for console connection, and a regular ethernet cable from one of the ports. I have tri...