Viten Patel is working as Technical Marketing Engineer (Converged Access) at Cisco. He was working as Wireless Escalation Engineer - Cisco TAC and holds many wireless certification like CCIE Wireless, CCNP Wireless, CCNA Wireless, CWNA, CWSP, CWAP, CWNE#146.
This document explains about the Prime Infrastructure WorkFlow for Converged Access. There are 3 WorkFlows (Small network, Large network and Centralized network deployment). This section shows the single switch Small Branch flow.
Below is a reference topology and deployment scenario
The WorkFlow helps deploy the above mentioned features. With just a few clicks you can deploy multiple branch networks with all the wired / wireless best practices for Converged Access.
What is achieved?
Some of the benefits of using the WorkFlow includes --
Simple to use
Masks the configuration complexity
covers most of the deployment scenarios
configure onces, use many times model
intelligence and best practices inbuilt in the tool
I would like to get some clarification regarding the user idle timeout WLAN configuration checkbox. I read on here that if you don't configure a idle time-out value within the WLAN the global system parameter will be used instead (which is 300 ...
Hi team,I pulled report from NCS for AP utilization, it gives multiple instance for same AP in AP Client statistics summary. ANy specific reason why its giving multiple instance. We are fine if its give two, becaus eof readio but single AP gives for insta...
Hello for everybody. There is a network of 5 remote sites and a central data center. We plan to implement the following wifi scheme - there are two wlc 3504 (high availability - one active and one standby ) in the central dc, to which all ap 2800 ser...
Hi Friends I have more Cisco Ap(Air-Cap-2702 E-E-K9 int my company everthing is ok but i have 2 problem1) When some user connect to specialy one AP these users after 2-3 minute disconnect from wifi what is reason? 2.4Ghz and 5GHZ is active . i ...
When connecting to the wireless network I have noticed that the clients will often skip an AP 10 feet away and connect to one two floors up and 100+ feet away. That doesn't sound very efficient and data rates are pretty poor.Can this be fixed?My test clie...