Follow these steps to set up the bridge as a rugged access point:
Step 1 Use the Quick Start Guide: Cisco Aironet Multifunction Bridges and the information in this manual to set up a bridge as a root unit on the wired LAN.
Step 2 On the Express Setup page in the bridge's management system, select Root Access Point from the Role in radio network pull-down menu.
Step 3 Also on the Express Setup page, enter an SSID that client devices can use to associate to the rugged access point. You might want to use the same SSID used by other access points on the same LAN segment as the rugged access point.
Step 4 Use the Security Setup page to enter and enable a WEP key that client devices can use to associate to the rugged access point. As with the SSID, you might want to use the same security settings used by other access points on the same LAN segment.
Step 5 Use an antenna, such as an omni-directional antenna or a patch antenna, that covers the area containing the client devices that will associate with the rugged access point.
I just want to upgrade the firmware to four devices that are already configured and working fine.I don't see documentation to perform a simple firmware update. Can anyone tell me where that is?I did download the latest update 220.127.116.11
Option 43 is what we are using to join. All of my access points are joining the VM WLC and not the local. Could it be a route issue? The new controller and the VM have IP's in same subnet. Just curious if it is a shorter path for t...
Hi, we had a vwlc pair in version Large 18.104.22.168. They are in different sites and vlans, and both vwlc's are in the same vlan as local ap's. They are in the same mobility group and we are running a flexconnect configuration. One vwlc in running on v...
Hi i have a DNA center, and a on prime CMX setup we have change our WLC to 9800' , and installed a DNA SPACE CONNECTOR to use DNA spaces instead of our CMX but some of our map is DNA SPACES, is still located under the old Structu...
Hello, I have catalyst 9130AXI connected to Catalyst 9800-CL (OS 16.12.5) installed on my Virtual Machine.I configured Mac Address Bypass on this version and it works well, but there are problem with 5Ghz radio, it keep restarting 5Ghz radio on catal...