Can you enable routing or Network Address Translation (NAT) on Cisco APs
The Cisco Aironet AP is a Layer 2 device. Therefore, the routing and NAT features are not supported on the AP.
The Cisco Aironet Access Point (AP) is a wireless LAN (WLAN) transceiver that acts as the connection point between wireless and wired networks or as the center point of a standalone wireless network. In large installations, the roaming functionality provided by multiple APs enables wireless users to move freely throughout the facility while maintaining uninterrupted access to the network.
Q. Can you enable routing or Network Address Translation (NAT) on Cisco APs?
A. No, routing and NAT features are not supported on APs.
Release notes / product overview / data sheet / FAQ
Weird issue.AP 1832i----switch(no trunk)-----DMVPN--WAN--DMVPN--WLC5520 126.96.36.199Sometimes PSK Auth process fails with message "wrong PSK" on Device. Sometimes it works. Seems like there are "timeslots", when it works - and when it does not work.Seem...
Hello I have had a number of issue trying to view my account on my mob phone. I keep getting a password message - which I cannot access due to the email it is sending it is not something I can access. I have been told to delete the free version...
Hi all,assuming my wireless client IP subnets are created on a non-VSS, stack, or SVL device.FHRP is realized using HSRP.So in my wireless VLAN, there are link-local Multicast messages for the group address 188.8.131.52 (HSRPv2).If I have Multicast support...
I was trying to figure out if there is a way from the CLI on an AP (a 3702i in this case) if I could tell which controller the AP was actually associated to. I can run a "show capwap client config" to show what the config is, but I have found some c...