i have make a new experience with the callmanage version, i work in a chemical factory and my job is network administrator.
We wentfromversion 4.3 and now we on the versione 7.3.1.
I have installed the COP file for Dual Mode for iPhone and have cinfigured all parameters. The device function correctly on Wi-fi network, and in 3G through Factory VPN. the device (IPHONE) is associated at my primary line but when i call with the iphone device on a internal telephone number (example my collegue) he does notsee the name desciption "allerting Name" but only the telefono number. If i register the iphone with a new line and no associate the device by cisco device i can configuring with out any problem and the allerting name is ok..
Hi everyoneThis is the new setup (Not access points joined to this controller)I have some cisco Aironet 2800. i joined this access point to vWLC version 8.10.130. but after while they disconnected from wlc randomly. in first i check network connection bet...
Hi,I want to see all clients in a spesific state on a 8500 controller, is this possible?I'm trying to find all clients stuck in DHCP. show client state summary - in CLI shows me the number of clients, but I want to know who the clients are.
We are pleased to announce the immediate availability of the IOS-XE release 17.4.1 for the Catalyst Wireless Controllers. The new code is now posted on the CCO and can be found at this link:
Hi board,I'm pretty new to IOS-XE based controllers. I cannot find any information about the "ipv4 acl" or "ipv6 acl" configuration on a policy profile level regarding the direction.In which direction is the ACL applied (and therefore the rules need to be...