After an upgrade to CiscoWorks Wireless LAN Solution Engine (WLSE) version 2.11, devices such as 1410 bridges (BRs), Cisco Access Point (AP) 1200 series, and AP 350 series show the Inconsistent state found for query interface.radio.config error message. This error states that Cisco bug ID CSCeh79045
To resolve an inconsistent configuration, there are several actions to try:
It is possible that the most recent inventory failed for the device. If the inventory is re-run, the condition may clear.
If the configuration value contested is user-editable, the problem can be corrected with the WLSE templates, the AP or BR GUI, or the AP or BR Command Line Interface (CLI).
If the configuration value contested is not user-editable, this is probably a Cisco IOS error. In this case, the affected AP or BR must be upgraded to the most recent version of Cisco IOS.
For more information on the WLSE known issues and their resolutions, refer to the Known and Resolved Problems section of Release Notes for the CiscoWorks WLSE and WLSE Express, Release 2.12.
Hi,I have my basic rate for 802.11a set to 12Mbit/s, and yet all the clients that associate to this wlan are showing 6Mbit as the only rate. CCX is not supported. I must be missing something here.. What could be causing this?
I am having an issue with my Cisco C819GW-LTE-MNA-AK9 ISR, when I try and connect to the embedded access point. It gives me a message stating the connection is refused. This is a new ISR and I had never configured it before, ...
Hi, i have 2 AP´s 2802e with the Mobility Express Software on it.I used the WLAN Provision to do the initial config.After this i install a dhcp so the two AP can find each other.Mobility Express: static IPAP: DHCPNow i wanna have static IP for the tw...
I currently have a set of 5508 WLC's that is handling my wireless environment. Need to add an Anchor Controller to handle the Guest wireless network. Can I have a 9800-L as the Anchor or do I need to use a 3504? Thanks
Hello, i have make this setup for the acess point and i get lost somewhere. i have a Cisco C887VA, router with secondary core for the acce point. version 15.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime...