Step 3 Send the CSR file to a Certificate Authority (CA) of your choice.
Note Once you have generated and sent the CSR file for certification, do not use the genkey command again to generate a new key on the same Prime Infrastructure server. If you do, importing the signed certificate file will result in mismatches between keys in the file and on the server.
Step 4 You will receive a signed certificate file with the same filename, but with the file extension CER, from the CA. Before continuing, ensure:
There is only one CER file. In some cases, you may receive chain certificates as individual files. If so, concatenate these files into a single CER file. Any blank lines in the CER file are removed. Step 5 At the command line, copy the CER file to the backup repository. For example:
Step 7 Restart the Prime Infrastructure server by issuing the following commands in this order:
- ncs stop
- ncs start
Step 8 If the Certificate Authority who signed the certificate is not already a trusted CA: Instruct users to add the certificate to their browser trust store when accessing the Prime Infrastructure login page.
Importing a Certificate Authority (CA) Certificate and Key
Step 1 At the command line, log in using the administrator ID and password and enter the following command:
aliasname is a short name given for this CA certificate. ca-cert-filename is the CA certificate file name. repositoryname is the repository name configured in Prime Infrastructure where the ca-cert-filename is hosted. Step 2 To import an RSA key and signed certificate to Prime Infrastructure, enter the following command in admin mode:
key-filename is the RSA private key file name. cert-filename is the certificate file name. repositoryname is the repository name configured in Prime Infrastructure where the key-file and cert-file are hosted. Step 3 Restart the Prime Infrastructure server by issuing the following commands in this order:
Copy the mycert file to the CA and get the CA back. Copy all certificates together for a chain which needs to be imported in the following order:
*Intermediate CA cert *
*Root CA cert *
Additional we need the p7b file from the CA which contains the chain.
ncs key importcacert mycert.cer mycert.cer reporitory myrepo
The restart is necessary before we import the p7b file. Otherwise we might get an
Import p7b file
ncs key importsignedcert mycert.p7b repository myrep
hello all, I am now having a Aironet 1815m and the SG-350-28p on hand, and i would like to put them together for internal testing. I have tried to put them together, AP powered, and however it seems cannot get the IP.so i cannot go in...
Hi,Currently we have a wireless environment with 18 APs and a WLC 2504 for a customer. Today our customer had a connectivity issue and told us several users disconnected randomly after 10 or 15 min being connected to the WiFi.We did a first check and went...
Hi all,Does anybody know how to change the authentication protocol for webauth in 9800? I noticed that WLC webauth on WLC 5508 works with CHAP. The 9800 uses PAP. I haven't found out how to change it to CHAP in 9800. I guess in WLC 5508 it is done in "Con...
Hi, We recently purchased brand new 10 units of Cisco 9115AXP and 1 unit of Cisco 3504 Wireless controller.The issue is, some of the Apple laptop (both MacBook Air and Macbook Pro) users couldn't see the SSID and if they see and connect, the connecti...
We are migrating a site from 5508 WLCs with 3502 APs towards a 9800 WLC with 9120 APs. To support a rip and replace scenario we loaded the 5508 with the 8.5MR5ircm image so roaming between the old and new network would be possible. DHCP has been setup wit...