Step 3 Send the CSR file to a Certificate Authority (CA) of your choice.
Note Once you have generated and sent the CSR file for certification, do not use the genkey command again to generate a new key on the same Prime Infrastructure server. If you do, importing the signed certificate file will result in mismatches between keys in the file and on the server.
Step 4 You will receive a signed certificate file with the same filename, but with the file extension CER, from the CA. Before continuing, ensure:
There is only one CER file. In some cases, you may receive chain certificates as individual files. If so, concatenate these files into a single CER file. Any blank lines in the CER file are removed. Step 5 At the command line, copy the CER file to the backup repository. For example:
Step 7 Restart the Prime Infrastructure server by issuing the following commands in this order:
- ncs stop
- ncs start
Step 8 If the Certificate Authority who signed the certificate is not already a trusted CA: Instruct users to add the certificate to their browser trust store when accessing the Prime Infrastructure login page.
Importing a Certificate Authority (CA) Certificate and Key
Step 1 At the command line, log in using the administrator ID and password and enter the following command:
aliasname is a short name given for this CA certificate. ca-cert-filename is the CA certificate file name. repositoryname is the repository name configured in Prime Infrastructure where the ca-cert-filename is hosted. Step 2 To import an RSA key and signed certificate to Prime Infrastructure, enter the following command in admin mode:
key-filename is the RSA private key file name. cert-filename is the certificate file name. repositoryname is the repository name configured in Prime Infrastructure where the key-file and cert-file are hosted. Step 3 Restart the Prime Infrastructure server by issuing the following commands in this order:
Copy the mycert file to the CA and get the CA back. Copy all certificates together for a chain which needs to be imported in the following order:
*Intermediate CA cert *
*Root CA cert *
Additional we need the p7b file from the CA which contains the chain.
ncs key importcacert mycert.cer mycert.cer reporitory myrepo
The restart is necessary before we import the p7b file. Otherwise we might get an
Import p7b file
ncs key importsignedcert mycert.p7b repository myrep
Hello, I have a Cisco 2921 router IOS 15.07 and I wanted to know if I could connect my Netgear Wireless router to it so that I could configure the Netgear as an Access Point? The Netgear wireless router has a section where it can be configured as an AP.Wo...
We have 2802's running 8.3.x code and a fleet of wireless comm badges that operate in 5ghz only. The vendor says to disable FRA which I did but I still see these things connecting to AP's that have the slot 0 radio in 5ghz mode. I would like for the XOR r...
Hello, I'm trying to make an AP join a controller over the internet, I think I've done all the setup needed to make this work, here's what I did so far : - booted the AP and defined the public IP address of the WLC in the WLC managers list( NAT ...
we have this AP AIR 2802E working as ME(controller), its firmware is 22.214.171.124 and backup firmware is 126.96.36.199 But a few AP (2802E) can be upgraded and is working, other APs(AIR2802) cannot be upgraded, so cannot join to ME (controller)&...
Hi,We have a WLC 5508 with 2 WLAN. One with 802.x WPA2 authentication and Second one with Web splash page authentication.We have a Radius server 2012 NPS. WAP2 802.x authentication work with Radius server.IssueSecond wlan Web splash page authenticat...