An attempt was made to run a link test, but the IP address of the access point (AP) or other wireless device with which to test the radio frequency (RF) link was not specified.
In the Link Test screen's IP Address of Access Point field, enter the IP address of the AP or other wireless device with which you want to test the RF link. For more information on this error, please refer to the section on Error Messages in Aironet troubleshooting guide.
Note: Dont click on the Default button when running the Link Test. Because it blanks out the IP address.
WLAN adapters (wireless card) / ACU (Aironet Client Utility)
Dear Sir/Ma'am,we have one cisco AIR-AP1832i-D-K9 access point., we changed this access point firmware as mobility express(AIR-AP1830-K9-8-10-151-0) but after that AP was continued are going to reboot. in this case, we need your help.why I am changin...
Hi all,I have a pair of 2504's running sucessfully for the past 3 years as a HA N+1 with 4 x 2602 AP's. Both 2504's have dual uplinks to a pair of 3560 switches (so they would be Active / Passive uplinks). One uplink on the primary controller ...
Followed the guides on setting Guest LAN using a Cisco 9800-l as a Anchor to another Cisco 9800-l.Mobility Tunnel is up between the Anchor and ForeignOn Anchor..Created DHCP Pool for clientsCreated anchor policy profile; in profile set VLAN for Guest...