How to configure LEAP on Cisco Airespace Wireless LAN controllers
To enable LEAP authentication on the Wireless LAN controller you just have to enable 802.1x based authentication on the controller for the specific SSID. To do this using the GUI complete these steps.
From the Summary page click on WLANs
Click on New on the right hand corner on the GUI to define a new SSID for the WLAN
In the WLAN > New page enter the SSID for the WLAN network and select the WLAN identifier from the pull down menu. Click on Apply. WLAN > Edit page appears
In this page under Security Policies --> Layer 2 Security , select 802.1x authentication from the pull down menu and click on Apply. You can also configure the 802.1x parameters available in the same page.
Once this done the controller will forward EAP authentication packets between the Wireless Client and the Authentication server.
Note: The Wireless Clients and the Authentication server should also be configured for EAP authentication.
Hello, I have Cisco Aironet 1852e with Cisco Mobility Express and I have a problem with this AP in my network.In my network I have 2 aironet 1850e series access points connected and when connecting the new one it is looking for a connection to o...
We had a finding as part of Vulnerability scanning of WLC - Upgrade to OpenSSL version to 0.9.8q or later on CT2504-WLC Please let me know, if below command will be workaround for this vulnerability. Also, please let me know, will there be any p...
I'm hoping someone can help me here, as I've been banging my head against a brick wall for well over a week on this now! A bit of background... We have an old vWLC in VMware and are moving across to a new vWLC in Hyper-VOld deployment: 184.108.40.206...
Hello,I have 2 Dell Force10 MXL10 / 40 switches that form a VLT domain. From each of these 2 Dell Force 10 switches, one port-channel configured in vlt peer-lag mode comes out and these two ports arrive on a Catalyst 4500 forming a single Port-channel on ...