Need assistance configuring adapter and access point security settings.
In order to use any of the popular security features, both your client adapter and the access point to which it will associate must be set appropriately. For more information on correctly setting your client adapter and the access point refer to Synchronizing Security Features section of Configuring the Client Adapter.
Refer the following URLs
1. Using EAP authentication in Cisco Aironet 350 and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
2. Using EAP Authentication in Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide, Release 2.5
Configure / Configuration issues
WLAN adapters (wireless card) / ACU (Aironet Client Utility)
Hello community,Is it possible to convert an AIR-AP1815I-E-K9 access point to ME (Mobility Express) version ? Already have some K9-C version working, but ME portal is unable to upgrade those K9 by itself. Thanks for your advises. Anth...
On a 5508 running the latest code, If I select DHCP mandatory on the Advanced page for a given WLAN, does that stop a client from using a static IP address, or are those two compatible such that they can coexist? I mean, if a client is set up with a stati...
Hi Team, I have configured TWO VLANS for LAN and WIFI... Wifi is configured and connected on ASA MaManagement port and wifi is working finewe are not able to access from Wifi vlan to lan VLAN Can any one help me to resolve the issue&n...
Hi Guys,Does anyone know how to factory reset Cisco AP 3802? I found a thread discussing Cisco AP 3700 (https://community.cisco.com/t5/wireless-and-mobility/factory-reset-air-cap3702i-a-k9/td-p/3327000). Does the same steps apply to Cisco AP 3802? Thanks.
Hello together, i am currently struggling really hard to get a AP2802i to run as a Bridge / WGB Mode. I have the CAPWAP Version and the Bridge-mode should be available, but its NOT. When i try to change to mode from "local" to "bridge" i ge...