If the wireless device has a firmware failure, you must reload the image file using either the Web browser interface or the 1100 and 1200 series Access Points (APs). Press and hold the Mode button for approximately 30 seconds. Refer to the Using the MODE Button:-
Step 1 Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point.
Step 2 Press and hold the MODE button while you reconnect power to the access point.
Step 3 Hold the MODE button until the Status LED turns amber (approximately 1 to 2 seconds), and release the button.
Step 4 After the access point reboots, you must reconfigure the access point by using the Web-browser interface or the CLI.
Note:- The access point is configured with the factory default values including the IP address (set to receive an IP address using DHCP). The default username and password are Cisco, which is case-sensitive.
Follow these steps to delete the current configuration and return all wireless device settings to the factory defaults using the web browser interface:
Step 1 Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later) or Netscape Navigator (version 4.x).
Step 2 Enter the wireless device's IP address in the browser address line and press Enter. An Enter Network Password screen appears.
Step 3 Enter your username in the User Name field.
Step 4 Enter the wireless device password in the Password field and press Enter. The Summary Status page appears.
Step 5 Click System Software and the System Software screen appears.
Step 6 Click System Configuration and the System Configuration screen appears.
Step 7 Click the Reset to Defaults button.
Note If the wireless device is configured with a static IP address, the IP address does not change.
Step 8 After the wireless device reboots, you must reconfigure the wireless device by using the Web-browser interface or the CLI. The default username and password are Cisco, which is case-sensitive.
However, you can use the Mode button when the AP has a corrupt firmware image on 350 series APs. You cannot use the Mode button to reload the image file, but you can use the Command Line Interface (CLI) through a Telnet or console port connection.
For more information, refer to these sections of the document:
I just got my hands of an Cisco Aironet LAP1142N-E-K9 and want to convert it from Lightweight to Autonomous. For that I need the imagefile "c1140-k9w7-tar.153-3.JD17.tar" I cant download it from here, nor find it elsewhere. So how do I get the imagef...
This should be a question with an obvious answer but the Google Gods haven't been clear. I'm trying to determine which image I need for a 3702i access poing with the master controller AP (mobility express) running 8.8.125 but can't seem to find anything o...
Here is the complete boot capture: If I interrupt the boot, I can tftpboot at the (RNAQ-C7) # prompt a new ap1g4 file as part.bin to the device with no change. #====================== Connected 6:07 PM 10/18/2019 ====================...
Hello,Since we upgraded connections between our buildings we will use central WLC (5520) on our central location. There is around 1500APs on all locations which will be adopted to that WLC.My concern is that when I use local mode, I got my traffic do...
I have a guest network set up that is completely isolated from production, the intent being that visitors are issued a username and can go out to the Internet while they are visiting. I'd like to fix one thing: The visitor connects to the wireless network...