How to disable 802.11n access to the guest WLAN (SSID "open")? The WLAN is already configured with 802.11g access ONLY but "N" clients are still able to connect.
All "N" connections must drop and reconnected via "G" only.
GO to WLAN SSID and under the QoS feature, disable WMM. WMM is required for 802.11N support. "N" requires WPA2/AES or OPEN authentication.
How to enable 802.11n access working for to the guest SSID WLAN for open Authentication?
We need to enable WMM is required for 802.11N support. Turn on Wi-Fi Multimedia (WMM) for quality of service (QoS)
. 802.11n uses principles from the WMM quality-of-service protocol for protocol improvements. To use these, WMM will need to
be set to “Allowed” or “Required” in your network if it’s not already turned on.
Configuring Your Network for 11n
The Aironet 1140-series Access Point interoperates with Wireless LAN Controllers like any other lightweight AP. Just make sure
you're running 5.2 (or higher) controller code and that your APs can discover and join such a controller.
Ensuring 802.11n Rates are Enabled
Step 1 Under the `Wireless' tab on the controller GUI, click on the `802.11a/n' or `802.11b/g/n' network setting.
Step 2 Click `High Throughput (802.11n)' to open the configuration page.
Step 3 Ensure that `11n Mode' is enabled. By default, all of the MCS (or 802.11n data rates) are enabled.
Configuring WLANs for 802.11n
In order for the wireless LAN (or SSID) to operate at 802.11n rates, two specific items regarding encryption and quality of service must be configured. As per the requirements of the 802.11n standard itself, all encrypted links must now use AES encryption. The alternative to this is running the WLAN with no encryption, which is entirely possible. However this requirement precludes the use of WEP, TKIP or any other form of legacy encryption when using 802.11n data rates.
In regards to quality of service, the WLAN must be configured to allow WMM in order for 802.11n rates to be operational. To configure this on the wireless LAN controller, ensure that the `WMM Policy' under the WLAN profile configuration is set to either `Allowed' or `Required'.
Dear team ; kindly i have minor alert in cisco prime config differences found between pi and controller , i tried to resolve it by going to configure -> Audit Now , after auditing i get only one option Restore Prime Infrastructure Values to ...
Hi All, I am currently planning a migration from a Cisco 5508 WLC with 2800/3800 series APs to a 9800 with 9100 series APs. We are looking to install the new 9100 APs in parallel to the existing and then migrate a given area by disabling the 2800/380...
Folks,I have recently purchased a Catalyst C9117AXI-EWC-B. I have been slowly finding out what this does. I have read almost everything that has been written about these but I have a couple questions. First I see something confusing. I am using an AIR-PWR...
I have few aps model: AIR-AP1815W-E-K9 with the ios version:188.8.131.52 that have uptime of more than 100 days, but the association time stays 1 hour or less, and reset.They losing the connection with the controller.They operate in flex-connect&...
Getting this error when trying to upgrade to Mobility express. Tried different version and always getting the same error. Image transfer complete.Image downloaded, writing to flash...do CHECK_ME, part1 is active partupgrade.sh: Error: image not found...