Hello together, i am currently struggling really hard to get a AP2802i to run as a Bridge / WGB Mode. I have the CAPWAP Version and the Bridge-mode should be available, but its NOT. When i try to change to mode from "local" to "bridge" i ge...
view more
Using a WLC 5508 and ACS for web authentication for users wireless users. The virtual IP 1.1.1.1 has been always set to take the users to the authentication page. All of a sudden it stopped and is now sending users to the page attached. ...
view more
Hello, I'm playing with two "28021-E-K9" AP with the IOS AIR-AP2800-K9-ME-8-5-151-0.tar installed in console session in CLI mode with a tftp server.When I connect both AP on my network one become Master and the other one is in the AP list. Good.But i...
view more
Hello, I have just setup a test vWLC in a lab and connected a AIR-CAP2702I-E-K, the controller can see the AP, I have configured a few SSIDs but I cannot see them being broadcasted?Any suggestions? Wireless
Just started to investigate a medium/large network setup where it seems all of the LWAPs are connected to switchports configured as trunks and all of the LWAPs are in local mode. Each switchport is configured like this... interface GigabitEthernet2/0...
view more
