You may need to upgrade the software due to the following:
Loading wrong image
The Workgroup Bridge code is stored in a Flash memory chip inside the WGB. Use the load option to load new code versions of the Workgroup Bridge's firmware and save it to Flash memory. For more information refer to Loading New Code Versions (Load).
Upgrade the workgroup bridge to a next immediate higher version. For example to upgrade from 8.65.2 -->8.89 order of upgrade is from 8.65.2 -->8.84 --> 8.85--> 8.89.
I have some Cisco Aironet 1700 APs (AIR-CAP1702i-E-K9) I'm trying to add to my LAN, however I'm unable to connect and configure them by every method I have tried. I can see the APs connect to the main switch and are assigned an IP address via DHCP. H...
Hi looking for a little advice, what exactly is 'Signal Quality' shown in the attached image (taken from Cisco controller)?Is it the same as RSSI (dBm) or SNR? And what do the values on the image tell me about all three user's Wi-Fi connections? Is 0dB go...
Hi! I am new configuring this type of WLAN. I got my AP/WLC in place. But all my AP's are set as WLC as well. How do I get them to just be AP's that are depending on my first WLC ? Do I need a new firmware , Or is there a trick in the...
Hi guys,I had thought that the air-ap1832i-e-k9c model was a dual-band device, but I have seen in the datasheet that it speaks of dual-radio, do you know if this model is dual-radio?If it is dual-radio, why does it appear at 0 in the Access Point Summary?...