An issue with iPhone has been seen when there are two SSID's from same WLC / AP. If connected to one and try to connect to other, iPhone shows unable to connect (whereas the debugs in WLC showing it getting connected and getting an IP ! ).
WLC is running latest 7.0.220. Also tried different combination like two open SSID's and changing between them or one SSID with 802.1x and other open SSID, not working.
Configuring Fast SSID Changing
When fast SSID changing is enabled, the controller allows clients to move between SSID's. When the client sends a new association for a different SSID, the client entry in the controller connection table is cleared before the client is added to the new SSID. When fast SSID changing is disabled, the controller enforces a delay before clients are allowed to move to a new SSID.
Using the GUI to Configure Fast SSID Changing
Using the controller GUI, follow these steps to configure fast SSID changing for mobile clients.
Step 1 Choose Controller to open the General page.
Step 2 From the Fast SSID Change drop-down box, choose Enabled to enable this feature or Disabled to disable it. The default value is disabled.
Step 3 Click Apply to commit your changes.
Step 4 Click Save Configuration to save your changes.
Using the CLI to Configure Fast SSID Changing
Using the controller CLI, follow these steps to configure fast SSID changing for mobile clients.
Step 1 To enable or disable fast SSID changing, enter this command:
Hi Team, We have experiencing some problems with this APs. Let's see if you can add some light. We connect the AP to the network with Internet access and connect to the AP through the SSID Provisioned, after that we configure the WLC with static...
my signal booster has a continuous fast flashing green light which i gather means that it is in th "configuration cycle" but never seems to stop.. ive pressed the reset button several times and even tried holding it in for 10,20,30 seconds over the last 3...
Hi Experts, Do you know any information about Ingress Protection Rating (IP) of Cisco Access Point 1850 ? I cant find any docs online mentioning about this Access Point. I only can find Cisco Access Point 15XX , which has IP67&n...
I have an 1850 access point running Mobility Express. It is working fine as an access point and I can SSH into it no problem, however, I cannot access the web interface using any browser. Tried Safari or Chrome.
When I connect using Chrome using ht...
Hello, I noticed on our 5508 WLC that an access point on the roof of one of our buildings is down (roof terrance). On the PoE switch is now shows Ieee PD instead of AIR-CAP1532E-EK9I have done a shut and no shut and I get the same. Nothing show...