Customers do not see the normal LED scanning when the Access Point (AP) first boots, leading them to believe they have faulty hardware.
It appears this issue is related to a manufacturing bug on the new APs. New units were shipped from manufacturing with the LEDs disabled after bootup.
This issue is documented in Cisco bug ID CSCsc63217.
The default configuration on the units has the LEDs disabled. Once the AP registers with the controller, the LEDs should become enabled. If the AP registers but the LEDs remain disabled, issue the config ap led-state enable configuration command from the controller to enable the LEDs. This command needs to be issued on the controller to which the AP is joined.
This issue is first found in version 3.0(3). It is fixed in version 4.0(155) and 3.2(116.21).
One reason for this issue could be that the APs are in site survey mode. In site survey mode, the AP acts as an autonomous unit and only shows ethernet link status until manually configured.
Hello, We've installed virtual WLC using AIR_CTVM-K9_8_10_151_0.ova file. The installation and basic configuration of the WLC is done successfully.We'd like to add a lightweight AP 2700 to the vWLC but the AP stuck in downloading state.&nbs...
Hi community,I've been receiving many complaints from users that were unable to connect to the corporate WLAN with PEAP-TLS (but also on BYOD SSID with PEAP).After investigating I found all those sites where with AP3702. Digging into debugs, I've checked ...
Hi forum, Do you have experience in implementing EWC-AP (91xx series with 17.5.x IOS-XE) as Master AP in a network with AP2802 (Aire-OS 8.3.150) as subordinates? Or with similar versions of OS. I experience that the AP2802 fails during image up...
Hi,My outdoor AP 1552 is unable to join WLC 2504 below are the log messages i am seeing on the console of AP.*Jun 24 09:19:12.107: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-CAPWAP-CONTROLLER*Jun 24 09:19:22.107: %CAPWAP-3-ERRORLOG: Go join a capwap cont...
Our architects need the RAL color code of actual outdoor APs. If it not fits, the APs should be painted. As I understood right, we then we will loose warrently.All I found so far, outdoor APs have Cisco Medium Gray color. Cisco Medium Gray 2 (anothe...