download TFTPd32 from Google and install it on ur PC.. point the image that you have downloaded in the TFTP server..
connect a Ethernet cable between ur laptop and AP.. both should be in the same subnet.. and connect a console cable and get the hyperterminal console access and issue the command.. make sure you are able to ping the PC and the AP and vice versa!!
AP#debug lwapp console cli or debug capwap console cli
AP(confg)int fa 0
AP(confg-if)ip addr <addr> <mask> (same subnet as that of the laptop)
AP#archive download-sw /force-reload /overwrite tftp://<tftp ip address>/<image name.tar>
Hello Experts, The configuration for malicious rogues that are discovered on wire is clearly explained with regards to setting the containment level. However when it comes to containment of Malicious rogues that are not discovered on wired, I do...
Cisco Access point 1142N-A-K9 is not joining controller giving below message.previously this AP was having static IP and was removed and kept and never used.i have done factory reset and now its not joining controller.Please assist, Thanks in advance.&nbs...
I've setup 1 x Controller and and 2 x APs. All of them are Cisco 3802 and all of them have same software 220.127.116.11 and Mobility Express capable. All of the APs are connected to same switch with and same access Vlan. These APs were bench tested and no...
Hi,There are several methods an Access Point can join the Wireless controller e.g DHCP option 43, DNS, AP HA tab etc. If an access point has joined a controller, how can we find which joining step was successfull for it join the controller ? Thanks.&...