download TFTPd32 from Google and install it on ur PC.. point the image that you have downloaded in the TFTP server..
connect a Ethernet cable between ur laptop and AP.. both should be in the same subnet.. and connect a console cable and get the hyperterminal console access and issue the command.. make sure you are able to ping the PC and the AP and vice versa!!
AP#debug lwapp console cli or debug capwap console cli
AP(confg)int fa 0
AP(confg-if)ip addr <addr> <mask> (same subnet as that of the laptop)
AP#archive download-sw /force-reload /overwrite tftp://<tftp ip address>/<image name.tar>
I'm with a problem between Xiaomi and external captive portal (+ external RADIUS), the wlc isn't processing back the requisition. My virtual interface address is 126.96.36.199 (for avoid troubles with cloudfare for example), and in callback moment that the...
Hello!We are just implementing a radiating cable to our cisco AIR-AP2802E-E-K9.We would like to set the antenna A to 2,4 GHz and antenna B to 5 GHz.On my WLC it is not possible, because only combinations of A or A+B or A+B+C or A+B+C+D are possi...
Hi Having an issue with the 9800 controller setup in sso, where I cant get clients to get a dhcp reply. The aps are up.. the ssid are up.. but external dhcp not so much I have tried setting it up globally under policy without effect. I hav...
I'm currently working on a small POC to install OEAPs so our call center employees can work from home (ideally to bring a phone home with them and connect it to the OEAP POE port). We have softphones too but apparently management is still asking to make i...
Rogue auto-containment may have legal consequences, so it should be clear whether or not you are enabling it.I think Mobility Express is not clear about auto-containment. I just found the "Rogue Policies" option in the Best Practices menu. This option set...