download TFTPd32 from Google and install it on ur PC.. point the image that you have downloaded in the TFTP server..
connect a Ethernet cable between ur laptop and AP.. both should be in the same subnet.. and connect a console cable and get the hyperterminal console access and issue the command.. make sure you are able to ping the PC and the AP and vice versa!!
AP#debug lwapp console cli or debug capwap console cli
AP(confg)int fa 0
AP(confg-if)ip addr <addr> <mask> (same subnet as that of the laptop)
AP#archive download-sw /force-reload /overwrite tftp://<tftp ip address>/<image name.tar>
We are trying to setup an outdoor wireless network with 1532I access point in autonomous mode. We created a 2.4Ghz network with WPA ver 2 and AES encryption. The problem is that some devices stay connected but can't access event to network (LAN or WA...
Hi, I'm doing project for a large company who asked me to order a few Cisco Aironet 1815w APs. Now that I have them I don't know where to download the CAPWAP controller based software to configure them (I'm assuming it is a software app similair to w...
Hi. I've been experimenting with 802.11w (Protected Management Frame) and can't get it to work at all. None of the devices I've tested with seem to support it. Before I spend any more time on this, has anyone actually seen it work in the real world, ...
Hi all,I'm not sure about the settings of the"Antenna Configuration" for an 1852E Mobility Express Access Point. If I look at the datasheet for the 1852E, it notes that 2.4GHz uses 3 antennas. -> Does that mean that for Radio 1 only 3 Antennas nee...