download TFTPd32 from Google and install it on ur PC.. point the image that you have downloaded in the TFTP server..
connect a Ethernet cable between ur laptop and AP.. both should be in the same subnet.. and connect a console cable and get the hyperterminal console access and issue the command.. make sure you are able to ping the PC and the AP and vice versa!!
AP#debug lwapp console cli or debug capwap console cli
AP(confg)int fa 0
AP(confg-if)ip addr <addr> <mask> (same subnet as that of the laptop)
AP#archive download-sw /force-reload /overwrite tftp://<tftp ip address>/<image name.tar>
There are three symptoms which have been reported and I myself have tested and seen on site.Short, 1-3 second audio dropouts whilst the phone is roaming in several locations around the hospital. This happens on multiple handsets. (I have a Meraki Packet C...
Hi, I have a customer using flex connect APs with locally switched WLANs. Recently we started implementing ISE for WLAN authentication. The customer has around 20 AD groups and wanted to have different ACLs for users in different groups.For this purp...
I use Cisco Wireless LAN Controller 2504 and AP 1852. I config AP joined to Wireless LAN Controller 2504. If Wireless LAN Controller reboot, AP not re-join to Cisco 2504.Please help me fix this problem.Many thanks.Regards.
The title pretty says it all. I have the layer 3 webauth enabled on a Cisco WLC 2504 WLAN with a self-signed SSL cert. I installed the root CA cert in the Android phone under Settings > Biometrics and security > Other security settings > Install ...
Hello, I have a Cisco 2921 router IOS 15.07 and I wanted to know if I could connect my Netgear Wireless router to it so that I could configure the Netgear as an Access Point? The Netgear wireless router has a section where it can be configured as an AP.Wo...