download TFTPd32 from Google and install it on ur PC.. point the image that you have downloaded in the TFTP server..
connect a Ethernet cable between ur laptop and AP.. both should be in the same subnet.. and connect a console cable and get the hyperterminal console access and issue the command.. make sure you are able to ping the PC and the AP and vice versa!!
AP#debug lwapp console cli or debug capwap console cli
AP(confg)int fa 0
AP(confg-if)ip addr <addr> <mask> (same subnet as that of the laptop)
AP#archive download-sw /force-reload /overwrite tftp://<tftp ip address>/<image name.tar>
Just wondering what the best practice is on using DHCP proxy mode vs DHCP bridging mode for roaming clients (L2 / L3 roam)? Does the DHCP proxy feature add significant time to the DHCP handshake and cause roaming clients to lose packets when they go ...
Hi all, I am having issues setting up a few Aironet 1262s (AIR-LAP1262N-E-K9) They are powered from a 3560 PoE-8 (only one at a time) and they power up...The power comes on and the light flashes green for bit (I assume booting)The light then is ...
Hi all, I am using WLC 3504 and i have created a open ssid that require web auth. I have also enabled a lobby admin account on my WLC to create accounts for guests to connect to this ssid. The default ip of the interface of this ssid is 188.8.131.52. For ...
Hello everyone,I am a new customer of Cisco Access Point AIR-AP2802E-E-K9C. I don't have much experience with this class of hardware Cisco. Could someone help me, how to configure this AP? I have experience with switches and routers. I would like, to this...
Dear all, I cannot reimage AP1852i through rommon mode .I tried below commands but it doesn't work. When it boot, it will load the old image (the old image has an issue so I cannot access to controller cli or webui)tftpboot AIR-AP1850-K9-8-5-151...