User is designing a mesh network (outdoor) and want to use some AP1552. This AP has 3 connectors N for antennas and would like to know if it can put a sector antenna working in dual band (2,4/5GHz, 802.11N) and the other 2 connectors with omnidirectional antennas?
The number part is: AIR-CAP1552E-A-K9 and 1552EU comes with separate radios.
It is suggested stick with the antenna configuration and not mix and match the antennas, this would be the same for indoor. Diversity doesn't work well if the antennas are mixed up. Not with that model mesh AP. Use three dual band antennas. They will have a mesh ap that the 2.4 and the 5ghz will use separate radios that will allow for using a patch for the backhaul but that's not available yet.
AIR-CAP1552E-x-K9 2.4GHz b/g/n, 5GHz a/n MIMO, Outdoor Mesh AP with external antennas
Access Point Bottom Connectors - Models AIR-CAP1552E-x-K9, AIR-CAP1552EU-x-K9, and AIR-CAP1552H-x-K9
Antenna port 4
Antenna port 5
Antenna port 6
LEDs (Status, Up Link, RF1, RF2)
AC power connector for model AIR-CAP1552H-x-K9 only
AC power connector for model AIR-CAP1552E/EU-x-K9 only
Access Point Dual-Band Omnidirectional Antennas - Installed Only on Models AIR-CAP1552E-x-K9 and AIR-CAP1552H-x-K9
Hello,I have 3 WLAN with QoS configured by metal policy : - Main network : Gold - SoftPhone network : Silver - Guest network : BronzeI want to configure QoS on VoIP traffic with platinum policy (SoftPhone network), but the rest of the traff...
Hi all,When I "apply" the AP 803's web setting the web page will occur error 404.The version of AP 803 is 15.3(3)JKI have been try to use the Browser:Chrome、Edge、Firefox , and also try the older version of the browserStill doesn't work!!How do I fix ...
wlc 5502 version is 22.214.171.124i have a ssid use by macos device,and disable loadbalance and 802.11rthe ssid use 802.1x authentication with windows 2012r2 nps service(radius)but apple device untimely disconnect,windows device is no problemi open a ssid...
Hi, I would like to setup a Palo Alto firewall between cisco WLC and APs to control some traffic. Anyone can share some idea for this? or send link in order to know what I need to pay attention to? Thank you very much.
If you are using UNII-2 Ext channels, is there a way to get DFS notices in the WLC log? I thought they showed up there by default, but I just found DFS pauses in the logs on several APs, and there was nothing in the WLC log about it. I've logg...