In order to upgrade from a VxWorks-based AP to Cisco IOS Software, your AP must run one of these VxWorks firmware versions.
If you have VxWorks with firmware version 12.04 or later, you must first downgrade VxWorks to one of the earlier versions. You cannot upgrade to Cisco IOS Software from VxWorks unless you perform this downgrade.
In order to run the upgrade process, the AP must have at least 4 MB of DRAM available.For more information on the minimum VxWorks versions requirement to upgrade to Cisco IOS, refer to the Components Used section of Upgrade Cisco Aironet AP1200 to IOS.
Hello everyone! I'm a beginner in the Wireless world and I want to change most AP names in my topoloogy while using Cisco Prime 3.3 (100+ devices). To achieve this I believe I need to: 1) Export a csv with the APs I want to modify.2) Modify thei...
Hi All- A colleague of mine grabbed a 3702i that I have configured as a workgroup bridge and hung it in the ceiling. I can get to it via ssh / http. Any chance I can convert it to capwap in place. Advice on the procedure.would be a...
I have been out of the IT world for a few years, but my current job is requiring me to take on more IT related tasks. One of my current tasks is to get a mobile "robot" to talk over wifi after a failure of an older setup (2 wireless bridges). I have been ...
Under Configuration -> Security -> Web Auth, on the new 9800 WLC you have a option called Web Auth Parameter Map.How many Web Auth Parameter Map can you have on the new 9800 WLC?I can't seem to find a number on this online. But would it be reas...