The physical and virtual appliances that NCS and Prime Infrastructure run in can be monitored via SNMP. To configure the SNMP agent on the appliance, use the "snmp-server" configuration commands in at the global configuration level in the command line interface, as shown below.
Enter configuration commands, one per line. End with CNTL/Z.
appliance/admin(config)# snmp-server ?
community Set community string
contact Text for mib object sysContact
host Specify hosts to receive SNMP notifications
location Text for mib object sysLocation
I have a single 3802i with CME 8.5.151. The wireless clients can ping their default gateway and any other wireless host. These same wireless clients cannot ping any non-wireless (aka wired) host on the same subnet. I've been looking thro...
Hi all, The wireless setup in my work environment uses AIR-AP2802I access points and they are managed by AIR-CT3504 WLC.My endpoints are mainly microsoft surface pro notebooks and notice the wireless bandwidth on all these notebooks is capp...
Hello everybodya few weeks ago I faced a major breakdown in the network because of a failure on the DHCP server.After a unpredictable power outage the APs came up and they couldn't contact the DHCP. Because this service is controlled by another team that ...
Dear,I have a CORE switch, which is a root bridge of all VLANs in my environment. I want to use flex-link on a particular port. When I set the flex-link feature on my CORE switch interface, will this cause Spanning-tree to be disabled only from the interf...