This message indicates that a client has left the AP coverage area and has reassociated to a different Access Point (AP). It is not necessary to perform additional troubleshooting when clients roam. However, if the APs are connected to switches, multicast must be permitted between those switchports. If you have more than one AP in your wireless LAN, wireless client devices can roam seamlessly from one AP to another. The roaming functionality is based on signal quality, not proximity. When a client's signal quality drops, it roams to another AP.
Wireless LAN users are sometimes concerned when a client device stays associated to a distant AP instead of roaming to a closer AP. However, if a client's signal to a distant AP remains strong and the signal quality is high, the client will not roam to a closer AP. Checking constantly for closer APs would be inefficient, and the extra radio traffic would slow throughput on the wireless LAN.
IOS Errors, Warnings, Statistics and Log Messages
DOT11-6-ROAMED: Station [mac-address] Roamed to [mac-address]
Hi, need help to understand what my problem is? Airplay situation is as follows:Wireless to wireless devices - working fineWireless to wired devices - working fineWired to wired devices - working fineWired to wirelss - NOT workingAny advise on what seems ...
I would like to get some clarification regarding the user idle timeout WLAN configuration checkbox. I read on here that if you don't configure a idle time-out value within the WLAN the global system parameter will be used instead (which is 300 ...
Hi team,I pulled report from NCS for AP utilization, it gives multiple instance for same AP in AP Client statistics summary. ANy specific reason why its giving multiple instance. We are fine if its give two, becaus eof readio but single AP gives for insta...
Hello for everybody. There is a network of 5 remote sites and a central data center. We plan to implement the following wifi scheme - there are two wlc 3504 (high availability - one active and one standby ) in the central dc, to which all ap 2800 ser...
Hi Friends I have more Cisco Ap(Air-Cap-2702 E-E-K9 int my company everthing is ok but i have 2 problem1) When some user connect to specialy one AP these users after 2-3 minute disconnect from wifi what is reason? 2.4Ghz and 5GHZ is active . i ...