Verify the software version of the Access Point (AP) and the client. The software options may not be configured on the AP, or the firmware may not have the feature required by the client card. The client card software may also be outdated.
Device cannot associate
AP 340, 350
VxWorks Errors, Warnings, Statistics and Log Messages
Greetings!I'm looking for some help to configure dynamic vlan (and IP) assignment for users connected to our wireless network.We use MobilityExpress as a controller and our Radius server is the Windows NPS Radius.I'm good with the vlan override config on ...
We will be having a deployment that 2 sites have both active and standby WLC.The APs in site 1 will connect to the WLC in site 1 and the APs in site 2 will connect to the WLC in site 2.If both the active and standby wlc is down on site 1, the APs will con...
I have a device N9K-c93180YC-EX and a PI 3.4I add the to N9K-c93180YC-EX to PI 3.4, and the prime said that device unsopported. I check the differents version 3.4, 3.5, 3.6, 3.7 3.8But in no version is it compatible.I it is rare that...
Hi, Stupid question, I need to reinstall MSE one the 3355 Appliance because the whole installation is screwed up. I downloaded the files from Cisco for the CISCO-MSE-L-K9-8-0-150-0-64bit.bin.tar.gz but how to do put this into a bootable format? ...