cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4111
Views
0
Helpful
1
Comments
dale.carlson
Community Member

We just recently updated from autonomous APs to LWAPP using a WLC 4402 (ver 5.2). The conversion went well and we didn't have any problems. However, being a WLC noob, I can't figure out how or where to remove or delete an AP object from WLC. I just had to replace one, and can't figure out how to get it out of WLC (or WCS, which we're evaluating, for that matter).

thanks

Comments

Thank you for your posting and interest in the Cisco Support Community.  For best practices on posting documents in this community you can refer to

https://supportforums.cisco.com/docs/DOC-6022#Can_I_use_documents_to_post_technical_questions

For technical questions related to a Cisco Product or Technology, we encourage you to post on the Network Professionals Forum (NetPro). For your specific issue, you can go to Wireless - Mobility - General forum

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: